mirror of
https://github.com/Grasscutters/mitmproxy.git
synced 2024-11-27 02:24:18 +00:00
69 lines
2.1 KiB
HTML
69 lines
2.1 KiB
HTML
|
|
|
|
OSX Lion integrated the [pf](http://www.openbsd.org/faq/pf/) packet filter from
|
|
the OpenBSD project, which mitmproxy uses to implement transparent mode on OSX.
|
|
Note that this means we don't support transparent mode for earlier versions of
|
|
OSX.
|
|
|
|
<ol class="tlist">
|
|
|
|
<li> <a href="@!urlTo("ssl.html")!@">Install the mitmproxy
|
|
certificates on the test device</a>. </li>
|
|
|
|
<li> Enable IP forwarding:
|
|
|
|
<pre class="terminal">sudo sysctl -w net.inet.ip.forwarding=1</pre>
|
|
</li>
|
|
|
|
<li> Place the following two lines in a file called, say, <b>pf.conf</b>:
|
|
|
|
<pre class="terminal">rdr on en2 inet proto tcp to any port 80 -> 127.0.0.1 port 8080
|
|
rdr on en2 inet proto tcp to any port 443 -> 127.0.0.1 port 8080
|
|
</pre>
|
|
|
|
These rules tell pf to redirect all traffic destined for port 80 or 443
|
|
to the local mitmproxy instance running on port 8080. You should
|
|
replace <b>en2</b> with the interface on which your test device will
|
|
appear.
|
|
|
|
</li>
|
|
|
|
<li> Configure pf with the rules:
|
|
|
|
<pre class="terminal">sudo pfctl -f pf.conf</pre>
|
|
|
|
</li>
|
|
|
|
<li> And now enable it:
|
|
|
|
<pre class="terminal">sudo pfctl -e</pre>
|
|
|
|
</li>
|
|
|
|
<li> Configure your test device to use the host on which mitmproxy is
|
|
running as the default gateway.</li>
|
|
|
|
<li> Configure sudoers to allow mitmproxy to access pfctl. Edit the file
|
|
<b>/etc/sudoers</b> on your system as root. Add the following line to the end
|
|
of the file:
|
|
|
|
<pre>ALL ALL=NOPASSWD: /sbin/pfctl -s state</pre>
|
|
|
|
Note that this allows any user on the system to run the command
|
|
"/sbin/pfctl -s state" as root without a password. This only allows
|
|
inspection of the state table, so should not be an undue security risk. If
|
|
you're special feel free to tighten the restriction up to the user running
|
|
mitmproxy.</li>
|
|
|
|
<li> Finally, fire up mitmproxy. You probably want a command like this:
|
|
|
|
<pre class="terminal">mitmproxy -T --host</pre>
|
|
|
|
The <b>-T</b> flag turns on transparent mode, and the <b>--host</b>
|
|
argument tells mitmproxy to use the value of the Host header for URL
|
|
display.
|
|
|
|
</li>
|
|
|
|
</ol>
|